Quote:
Originally Posted by O3HDF150
Looking good...  What is this going in?
And, are you planning on making any to sell? |
Thanks. It's going into a 68 Acadian (same thing as a Nova but says Acadian on it instead). No sorry, not planning on making any to sell. This one alone has taken me probably 15-20 hours to make by the time I measure, cut, weld, clean and on and on. Not that I am comparing in any way, but now I can see how some of the custom stuff that Fesler and other places do cost so much. The labor is the killer.
Quote:
Originally Posted by GrabberGT
Very nice. What are your plans for an arm rest/door?
|
I'm hoping to use the Fesler door panels. I've also debated about taking a shot at making my own. We'll see.
Got a little bit done today. Moved the shifter back into it's original location. I like it better there. Also had to cut a few pieces out and I made the ebrake hole.
I know the one side is a little bit off, but it's a one off piece. It all can't be dead on. Plus with the leather, it will never even be noticeable.
I'm not sure if I like the cup holders I have. I think they are a little too big. I want a set that when I put a regular pop bottle into it, it doesn't flop all over the place. The ones I have have about half an inch all the around still. Does anyone know of any that fit a bottle snugly.