been pretty busy so i haven't gotten a lot of time to work on the car. i did get the other muffler done so that makes 2.
and the fuel cell done.
mocked in the cage to check fitment and measure for the fill panel i needed to make.
needed to cut the stock fill hump shorter and fill it back in.
then using 3M 8115 panel bond adhesive i mounted the cage to the car. it holds the cage in as well as doubling as a seam sealer. its also welded in a few places and will also be tied to the frame and cage.
after it dried i put the cell in.
at the lowest point its 8". thats more than i had in my '67 and there has never been a clearance issue with that car.
