Here is a small update on the engine compartment.
Here is a fan shroud that I had laser cut, and then Tim bent the ends up and welded to the radiator. They are Spal fans and should pull alot of hot air.
I had Tim straighten the radiator support. By straightening it we gained over an inch for the intake on the supercharger.
Also made mounts for the intercooler.
Since the radiator support was made straight the hood latch is going to get modified. I also made a new front end support and had it laser cut.
All the intercooler plumbing is now done and it looks real good. Tim is real good at laying stuff out, making sure stuff is symmetrical.
This is why I have two different size fans. The intake on the supercharger needs to go somewhere.
as usual more updates later...