Thread: Driveshaft angle/am I screwed
View Single Post
  #1  
Old 05-03-2011, 02:03 PM
Lenie's Avatar
Lenie Lenie is offline
Senior Member
  
Join Date: Jan 2007
Posts: 1,516
Thanks: 8
Thanked 36 Times in 19 Posts
Default Driveshaft angle/am I screwed
Engine at 4* angled down at yoke, rearend pinion is also at 4* facing down and sits higher then the transmission yoke. Driveshaft is installed and angles up from the tranny to the rearend at 3*. From what I've been reading, this isn't good is it ?
__________________
Lenie
Reply With Quote