[fletcherscustoms]

We have been in a holding pattern for a few weeks waiting on the some parts. Finally things are showing up so work has started again. Received a couple of boxes full of parts from Moser yesterday to finish up there rear end and make the car into a roller. My first time dealing with 35 spline axles, wow there freaking huge, but a 1000 ft lb of torque motor there gonna be needed. Also a pic of the 9" Moser Aluminum "through bolt" center section, with 35 spline Wave-Trac, 1350 series aluminum yoke, and Aluminum pinion support.




I took a a wheel off my car and threw it on the back just to get a idea of what it looks like. Its a 20x13 with a 345 on it, and we got a easy 3" of clearance left.



The car is setup for a 6" rocker height at Ride height, gonna be crazy low. Here it sitting at about 7.5" last night. I couldn't get it off the lift arm to get it sat down all the way.