[IMG]
[/IMG]
Got a start on the chassis jig yesterday and pretty darn pleased with it so far. I have four bolt adjusters on the legs. I wanted to do minimal welding on the two beams so built the supports this way. I have to do a couple cross supports but I may just bolt some angle iron on each end where there already holes...to save welding and risking deforming the beams.
Have to do leg braces yet also...
I like the notches in the beams...a 2x4 fits in perfectly for quick cross supports. Also will see if I can pick up some 1-1/2" tubing I can tack in place.
I left the supports a little long and set them both at the centerline of the wheelbase...figure that might come in handy for placing the jigs for the uprights.