Quote:
|
Originally Posted by Sparky67
The orginal poster wanted DSE's Quadra link and DSE's Mini tubs, and if you use http://autoweldchassis.com/cp.ivnu
2 x 3 x 11 gauge steel is .125 inches thick.
rear sub frame rails then all you need to do is notch the sub frame. I really don't care for 21st Century mini tubs though. It doesn't have the quality of DSE's mini tub kit, and the factory look. |
I also prefer the factory look of the DSE minitubs, but that narrowed rear frame member on each side leaves me a little nervous. As you note you need to narrow the Autoweld Chassis replacement frame rails, thus not really (in my mind at least) solving the issue.