DSE subframe and brake lines
Just got my new DSE front subframe ( to replace my stock one that got bent)...
For my stock subframe I bought all the pre-bent stock type brake lines etc so everything just fit and bolted to all the stock spots. With the DSE sub I noticed that there are no frame tabs or bolt holes to mount all the brake lines etc. When I place the stock brake line that runs across the bottom of the stock frame to go to the pass side front brake it overhangs quite a bit when it goes up and over the rail...obviously since the DSE one is much narrower in that spot....
So for all the guys that did the DSE sub.....did you make custom lines, weld on tabs etc etc ?
Mine is all assembled and powdercoated so I dont want to weld anyhting on....
I guess my best option would be to cut that line alittle shorter, bent it and re-flare it...... then drill and tap any holes where I want to mount brackets etc.
I was just curious how other guys did their lines and frame brackets for the brakes
|