Quote:
|
Originally Posted by Mean 69
Den, I'd get dimeensions for the GN hubs before I would buy them, pay particular attention to the wheel register diameter versus the diameter of the hub in that area, I have to lathe down the drive plates and the covers on the floater rear, to fit inside the wheels I was using.
Mark
|
I have spoken in depth with Rory over at Coleman, I am going with Impala aluminum hubs drilled with a 5X4.75 pattern. The hub snout is 3" and the rotor drive plate is part of the backside of the hub. The studs are still 5/8" but McMaster has a solution to that...1/2X20 threaded coil inserts with stake in place drive pins.