Thank you, Wayne!
This weekend I was able to resume on the car. I was able to finish up welding the driver side inner wheel well and I started the passenger side. I ran out of welding gas today so I was not able to finish welding it. I'll have to do that next weekend. I used the remainder of the day today to start cutting the tubes to make my engine mounts. I had to shim the body dolly and then shim the engine to get it centered and level, but the lesson I learned today was that I should have located the car in the garage farther so I could shut my garage door without disturbing it. I didn't- so I will have to do all that again next weekend.
The last pic I took shows a gap from the tubing to the dr side frame rail. When I position the tube correctly, that gap goes away. It was the only pic I had in this view...
|