The fitting that is included in a Wilwood threaded M/C is is specific to the thread on the M/C & then to a -3 AN male ..
If you want to fit CV's on the Wilwood M/C.. You will have to machine the thread to match the Wilwood M/C & make sure you use a EPR o-ring..
I have very little experience with Wilwood components.. I only worked their for 10 yrs!
Quote:
Originally Posted by rwhite692
Thanks Cris, that is good info, much appreciated! Your fab work is just beautiful. You mentioned that wilwood now sells them with a threaded female boss for the reservoir, do you happen to know if that thread size is the same as the male on the CV reservoirs?
|