Quote:
|
Originally Posted by Steve1969LS1
Is this really the proper forum to critique the suspension choices on a car not even done yet?
|
Yes, it is. The "bragging" photos of the suspension were posted here so here is where the critique should take place
Quote:
|
Originally Posted by Steve1969LS1
Also, in regards to the J-bar, if you read the post you would see that they are swapping that out for a PHR later on. Didn't mean to start a debate on T/A theory in here.
|
.
I'll critique that when it happens too. Based on what has been so far they will get that wrong as well.
Quote:
|
Originally Posted by Streetfyter68
Maybe the design will work fine?
|
No, it won't
Quote:
|
Originally Posted by streetfyter68
Now if we could only get Dennis to attend charm school.
|
Ahhh, probably not. Steve1969, that was a funny response, I almost laughed
Look, the bottom line is that the design obviously spent zero time on an actual spread sheet to see how it will respond dynamically (which is never wrong and should always be used as a starting point). It was about how pretty we can make this device that we probably don’t even know the name of. I hope it holds the axle place long enough to get it on and off the trailer. Maybe we’ll put it on a race track someday….of course as long as no other cars are there as one might throw up a rock chip or something.
OK, off soapbox. The design doesn’t work as installed, it doesn’t on paper and won’t on the track…or maybe even the street for that matter. It shour looks good though.