Quote:
Originally Posted by LarryC5
Sieg,
Looking very good! I'm about to start on one myself. Are you considering making removable in the event you need to service the shifter?
Larry
|
Current plan is to make studs out of panhead allen bolts, grind the heads flatter and tack them to the tunnel or a plate that gets tacked to the tunnel. For the console center mount I'll tack a similar stud on the tunnel cover and use a rubber spacer to set the height. The tunnel will be covered with Dynamat Extreme, I may double layer the tunnel where the cover flange contacts, that will add a little clearance and insure a good seal.