from there it was back to suspension mock-up (with the second iteration of front suspension geometry)
brackets designed and laser cut by a buddy (all to be replaced this Christmas with the third and final, and amazing, iteration of the suspension geometry; with huge props going out to Bryce for a hand in making it right!)
I then began working on incorporating bumper mounts (again, being reworked this Christmas)
solidifying engine placement (Hemi soon to be replaced)
rear suspension
rear crossmember/bumper mount replacement (slight rework coming, nothing too major though)
beginning initial mock-up of replacement core support
decisions on what to do about headers (irrelevant at this point)
and this is where I ended this past spring. I could have pulled it of the table with some shock mock-ups or even using the stock Viper shocks I have under the work bench, but I wisely chose not to.
