Finally for this round of updates is a couple shop photos. First is my car in it's new resting spot. I picked this space because I have the fence wall to hang my project white board and inspirational rendering. I also have a couple tables tucked behind the car for working on and laying out parts. On the right of me is a 65 Mustang which unfortunately needs a serious complete overhaul, it's pretty rough. Sad for her but lucky for me the student that owns this one won't spend much time working on it. Based on what I saw in the last 2 semesters it seems more like she uses the shop to store the car rather than work on it. That translates to no grinding particles embedded in my windows and no careless dents in my car caused by not paying attention while working. I'm figuring my spot is one of the "safest" spots in the shop, lol!
Our class has 15 students, 9 are younger and 6 are older retired guys from the community that take the class so they have a shop to work in and can tap into my professor's expertise. As a result we have a pretty good variety of project cars in the shop.
These two are younger student's projects. The '53 Chevy 4-door was purchased with the top chop done and the owner is going to finish the body work, shave the door handles, french the lights, and spruce up the interior a bit. The plans for the bug keep changing, but it's for sure getting some sort of top modification, will be fenderless and have 17" wheels. This student expects that it'll take him 3 years to complete. Makes me think I'm nuts for wanting to do a complete rebuild on my car, exterior, interior, drive train and suspension in the 6 remaining months I have until graduation. I'm pretty focused, determined and had the whole project mapped out before school began so I think I can do it. Let the thrash begin!
This old guy project is very cool, a 64 Fairlane that has been back halved with a disc 9", a full roll cage, rack and pinion and a healthy fox body 5.0. He'll be putting a lot of street miles on it so he opted for a 26-10.50 rear tire but wanted a deep offset on the rear rims. There's room for bigger meats later on if he decides to go that route. Behind him is another old guy straightening out a '40 Ford with street rod plans.
Some other projects include a young guy 62 Impala 2 door post restoration, an old guy trike with a VW rear half and a custom made chopper front half, and an old guy 53 Chevy pick-up street rod. I thought I should share this one because of it's uniqueness. It's a young guy project, a '37 Hudson Terraplane. Yeah, I never heard of it either and didn't have a clue that it's one of 500 two doors produced that year. He found it for a cost of next to nothing in someone's back yard with a surprisingly straight body and is currently working on a top chop, after which it will get a full street rod treatment. He bought a 6.0 LS motor a while back but isn't sure yet if he's up to the task of converting it and is considering a traditional small block Chevy. Either way he said not to put where the school is located for fear that the hard core Hudson freaks will find out and steal it from the shop to prevent it from being hacked up, lol! Too late though, the roof has already been cut off and the posts sectioned since this photo. Should make a REALLY unique street rod.
