Thanks, yeah, 12 bolt. I was planning to mount the uppers as close to the center as possible, on the front side of the tubes. I looked at mounting them on top, a little behind the axle tube center, to get a longer upper arm, and not cut into the floor, but that raises the roll center up by 3 inch's, not sure how much effect that would have, and how much the longer upper arms will effect the pinion angle through the travel ( no cad program) thats why I'm posting here I guess), but thats how most of the aftermarket units are setup ( compromise? )
any input appreciated
Thanks, Steve
Last edited by SteveN69; 09-29-2011 at 12:15 PM.
Reason: mistake
|