I got the one piece floor in and much to my suprise the subframe bolted right up and everything went well on that end.
Yesterday I cut out the trunk pan, the more I looked at the tailpan the more I knew it needed to be replaced aswell. I saved myself about 100 spotwelds by just cutting it out as one piece. The previous owner did a pretty terrible job doing Qtr skins which left me 5 spot welds on each side of the tail pan, and a huge discusting bead weld on the bottom of the qtr I needed to cut.
I started to mock everything up in the trunk area, I still need to make some fill plates for the trunk floor. I am waiting on a new outer wheelhouses, tailpan and inner panel. I am still debating if I want to replace the Qtrs while I'm in there. I dont do it now I think I will kick myself later.
Has anyone had any issues with Qtrs from National Parts Depot? I got my floors there figured I would use them again.
well on to the pictures
