I was sent a diagram by Chassisworks. It shows that the mounting brackets on a Camaro are to be 4.5* from parallel to the carrier mounting surface on a Ford 9" such that the bracket is angled slightly towards the rear of the car at the bottom (the bottom is farther back in the car than the top). The measurement is 4.0* on the Mustang version. Therefore, on the 12-bolt - the measurement would be the same, but in the opposite direction. PM me your email address and I'll send you the diagram.
__________________
NCSU MSME 2005
1968 Camaro
350
4-speed
-under re-construction
1989 Camaro RS
|