I have started my project again, and I have decided on a new route.
I know this is similar to Project Getaway but I have done almost all of the work. They had some awesome ideas though!!!
Chassisworks front clip- altered the ride height so the car sits 2.5" lower
Chassisworks canted 4-bar
Custom roll cage and sheetmetal
Turnkey Engines LS3
T56 6 speed
Luxury ID wheels and Nitto INVO tires-19x12 with 345/30R19
18x8 with 225/45R18
Some of these pics are hard to see. I am not sure why some of them are clear and some are not.
The next updates will be the stretching of the rear wheel openings (not sure how much I am going yet???) and the roll cage followed by the sheetmetal
Where it started
All of the undercoating
Now its clean
You can see where the clip was raised in the car
Rear clip welded into place
This is where the rear clip was tied into the frame
