Quote:
Originally Posted by intocarss
You're correct, .65mm is equal to .0255" . It does put some stress on the studs, I am running ARP extnted studs and a custom 1/2" & 1" hub & wheel centric spacer made for these wheels..Some people had issues with the wheel nuts loosing up,
I haven't had that happen. I also have been checking the lugs after each drive so far and all is good. I may get flamed here... But I would also say "how accurate" are some of the lower end wheel's bolt hole spacing people run and have no issues? I hope it works out if not I'll have wheel adaptors made. And thanks for the complement
|
These are supposed to work.
Varinuts, they are about 1/4 of the way down the page. I am sure somebody makes these with inch measure treads. I do not know anybody that has used them.
http://www.serpentautosport.com/HTML...20Spacers.html