[norm86]

that was paint on top of a s**t of bondo a 1/4 inch thick. Back form being sandblasted.. and to work i go. inner rockers were shot right below of the cowl sides on both sides.front floor pan too on both sides. made the lower section of the inner cowl because it was on back order next is the right side which the cowl side was available so i used what i need then i tackle the floor pan the back seat floor pans on the left and right side were both ate which extended to the inner 1/4 brace so i removed the brace replaced the bad section and remade the lower part of the brace on bothsides