Ok before I start a Part III build thread, I figured I would do some updates of stuff I got done before I dropped it off at JCG.
First I adapted a RideTech/Coachworks camaro fuel filler neck to work with my tailpan. I used the tailpan section from a '68 Camaro and cut out the recessed section of the donor piece and cut out a matching section on my Cuda tailpan...then it was dialed in and fully welded.
I removed all the original mounts for the stock license plate and am currently building an aluminum license plate holder that will be held on with magnets
That way I can pop it on and off easily and have the tailpan look totally clean when I want to....and fill the car with gas.....