Thanks guys...
Flash, every time I see your car, I think of this song...
https://www.youtube.com/watch?v=sQTu9vx-laY
Here's the motor with the new Dynatech headers and the halfway put on plug wires. I want to route them under the headers, but the driver's side header is tight against the block around cylinder #5. I guess I'll just have to go over the headers.
I didn't mess with the wires today. I decided to finish up mounting the a/c condenser and trans cooler. Had to make some brackets to mount them. Anyone know how to adapt -an fittings to stainless hard lines?