[GaryBetsy]

Hey everyone here is another update of our build. This is step one of our front end bumper construction and lower valance. After spending the time to go ahead and fabricate our rear flush mount bumper. We started to look at the stock front bumper and decided that it just wasn't going to work. So we fabricated one from scratch just like the rear bumper. After looking at how we changed the shape of the rear quarters to fit the stance better we went ahead and used our same jigging plates from the rear and used them on the front. After doing that the lower valance was too narrow and we went ahead and changed that as well. We fabricated our own bumper mounts and fabricated the bumper out of 1/16" ga. steel. This stage only shows the basic shape and lay out of us fabricating the bumper and extending the lower valance. Stage two of the front end to follow. Take a look and tell us what you think.