Thanks every body. Saturday I went out an finished the Dynamat behind the pedals on the fire wall. Today we started the wiring. We installed the fuse block and laid out some of the dash wiring.
We also put the rear end back in the car. We noticed the top shock mount looks like its not letting the bolt go straight through the end of the shock. I'll go take a picture and post it now.
If you look at the rubber in the shock mount where the bolt goes through you can see what I'm talking about. If I disconnect the bottom of the shock and tighten the top the shock will angle away from the bottom mount. Its like they are not in line with each other.
These two pictures are with the top and bottom bolts through but not tight.
I think its because the frame rails and the cradle have a little different shape where they mount together.
Let me know what you think.