Thanks man..its so nice to work with all new parts and finally get to the good stuff.
Found some time this weekend to try to wrap up things as I’m waiting on the fuel tank, lines, fitting and interior wiring harness. The steering links needed to be torqued and have cotter pins put in, got that all done. Some of the steering column to floor hardware needs to be ordered which will happen sooner than later. I also took the column out and scuffed it and gave it some black paint. When I bought the front accessory kit from the forums the guy sent me the power steering hoses also. I had forgotten about them until I was looking for my coil packs. I looked at them and realized that the correct fitting have already been put on...bonus!! So I was pretty stoked about that as its one less thing to worry about. That should just about wrap up the steering part of the car.
I also did a mock up for the wires and coils. I’m thinking I’m going to put the coils inside the cabin or mount them on the sub frame. I just have to figure out how to run them under the headers and have them look neat and not make contact. I think it shouldn't be too hard. Another cool surprise was that with the dynatech headers I’ve done a lot of reading stating that you need to run flexible msd wire ends for the 7 & 5 cylinders as the headers is bent up to clear the steering box. I order 2 sets of msd boots from jegs on Friday. Well while mocking up the wires I noticed that the ends of the taylor wires had msd ends on them..not putting one and two together I was adjusting a wire and pushed on the boot end. Well it bent to a 90 and stayed...sweet I already have what I need...another bonus.
I ordered a couple of items of Friday from jegs that where needed. My order consits of: (2) set of msd wire ends which I don’t think I need now, apr header bolts, an braided extender for the oil pressure gauge, a shifter boot and trim to finish up around the shifter, and for the (5) - 2 1/16" gauges I was having a hard time finding something to house that many and not look bad. Most companies only make a 2-3 pod to mount to the underside of the dash. I didn’t want to run a 2 and a 3 so I was looking for other options... Whie searching I came across a 5 pod angled piece made by autometer for a jeep that im guessing Ill have to modify some but I think it should work so I ordered that also. That shipment should be here early this week.
Being that I had been looking at the motor for almost a year with blue tape on it I figured that the motor and transmission are in for now why not finally uncover those valve covers and put the intake on for a final fitment, hopefully. So that is what I did. I also got a couple pictures of the rear end complete other than tightening everything. Timmy cleaned up and painted the tail tight covers, might have them done in all black as I'm not too sure about the silver we’ll see. Grabbed some shots of the shifter position too as I have had people asking. It’s the white lightening from American powertrain, really a quality piece with a ton of adjustment. Onto the pictures...
much more to come...