Quote:
Originally Posted by will69camaro
Awesome. What are you having done on your Nova? They just got my car this past weekend so similar timing for drop off. I'll be headed up there hopefully this afternoon to give them the door hinges and templates for the DSE quadralink brackets. Definitely a good group of guys over there. Helped me make the decision to use them easier!
William
|
Quote:
Originally Posted by will69camaro
I went by last night and checked out the progress as well as your nova! Looks like you got a very good start on that nova. I like the color a lot. Plans for powertrain? Apparently you're working over the transmission tunnel for clearance (reason for the visit?)
They're telling me mine could have sheet metal back on the rear by Friday/Monday. It's moving along VERY quickly. I'm going to have them do the trunk pan and the floor patches as well while the car is there. Labor rate and hour estimates are good. I'm getting excited to get it back already and it's only been gone a few days! 
William |
Yea, I believe you were pulling out as I was pulling in last night actually haha. Really like your other Camaro as well. Yea they are clearancing the tunnel for the T56 and I am hoping I can have them do a few other small fab/welding jobs for me while it is there. Hoping I can get them to fab up a DBW pedal mount, clutch pedal stop, and hopefully weld out my clucth master bracket to the firewall if budget allows. Appreciate the compliments on the car its not much but it is getting there, it has been a really slow moving project but should make for a fun driver. Drivetrain is a cam only LY6 6.0 with L92 heads and LS3 intake.
That is moving fast for the new sheetemtal install, was checking out the DSE tub fit up while I was there. I'll be headed over there a few times a week until mine is finished up so I am sure we will run into each other if your there in the evenings.
