[boostin05blacks]

Feels like I’ve been working on the car a ton but not to much is actually done. Received the vaporworx tank from Rick yesterday so we tried to wrap the fuel system up. The fuel lines are pretty much wrapped up. Made a cross-over line for the fuel rails and ran the main line under the car on the inside of the frame rails and attached it with 1/2" rubber wrapped clamps. Came out ok but where the floor meets the subframe connector the fuel line looks to be the lowest point. I’m either going to make a small channel for the line to fit into or move the line to in-between the frame rail and pinch weld. How is everyone running their lines? Also made another small line to attach to the tank and hold the fitting for the pressure sensor. All that is left is the AN fitting that connects the AN line to the actual tank pump, should be here sooner than later.

In other news we've been working on the wiring of the car. This is going to take some time and it has to be routed very neat, so were going slow. Got the main fuse box and rear harness pretty much worked out.

We received the hightemp boots for the plug wires as they are very close to the headers in many spots. So I did a dry fit on them. Still need to figure out where the coils will be located. In front of the motor on the subframe or in/under the firewall behind the motor. Neither way is going to be easy but I'd like a clean installation. Any suggestions?

Also we installed the water sensor on the water pump housing as there was already a hole in it from the previous owner so that is done. Other than the injectors, coil location, and headers to be tightened the engine is done.

The engine wiring should be here late this week or early next week. So that will be soon. Here are some quick pictures..