I slipped the front clip in today, getting set up to install the new side rails and cross supports. Here is the front; yes, that axle centreline is ahead of the wheel well centreline, guess what comes next...
Close up, the bottom a-arm looks like it is not level now because the car is sitting level, when it sits on the ground there is a slight rake that brings that lower a-arm back in where it belongs.
Here is the interior, front rails with temporary supports in, once I measure and true everything the side rails and cross supports will go in. Then the new floor.
I have also done a bit of work on the rear cross member, you can see how much higher the drive shaft and transmission tunnel comes in with the new drive line.
Its hard to get a full image of the car becuase my garage is too small. Once I get it on the wheels I will roll it out to clean up the garage and get a few images of the entire car.