[Datsbad]

Well I was wondering if anyone else has used them...looks like good reports.
I am on my 3rd oil pan from them . First pan we had ona engine sitting on the stand. Before any oil was put in the assembly lube leaked out of it at the welds.
After a phone call and having to be rude they decided to help. That pan was sent back and it was just touched up and welded over again . After start up on the car we noticed some more leaks. Sure enought the pan leaks from about every possible pin hole etc.

We decided to get the car tuned on the dyno and make some pulls and address the pan a little later.

Again after extreme contact with CHAMP they decided they would build another and send it to us. The old pan would be returned then.

Now here is my problem . The new pan does not sit flat on a bench or if you put a flat edge to it its clearly not going to seal. This has caused headers to be ruined, a oil soaked underside of the car from oil pan to gas tank with this pan and Im real scekptical to use it again .

Of course they say " It will be fine" . Whats your guys thoughts?