DOOR cuz I'm learning that if there is rust on one side better do the other side too! Sure enough, driver's door that looked good on the outside was rusted all along the bottom
This time I used the Eastwood door skinner tool and what a difference - all I had to do was grind down the spot welds and pull the skin back
Who ever said to grind the edges of the door has not used one of these and should
So guess what I'm doing tomorrow? It's gonna be 80 out and I need to clean all this mess up and get some POR15 on the shell and paint it black, don't have to worry about this rust coming back!!!!!!!
Using a door skinner, easy job!
Rust never rests, what's under your skin?
Over all not too bad, another skin in route.
I have been looking at the doors that only replace the outer skin with a patch .... now I know what is under the skin and it sure would have continued to rust.
If it's worth doing it's worth doing right, thanks DAD
Thanks for looking,
Michael