here are a few of the pics. still not finished, but close. the main piece still needs to get extended all the way to the fenders and where the top piece flares out isnt quite done. the whole back side of the top piece rolls down 3/4" to make a nice lip in the rear, but there isnt one yet where the piece slopes down. when this piece is welded in the transition between the center and the little edge flares will get radiused.
im not totally sold on the edges flaring out by the fenders. its small enough that they dont really distract you, but not large enough to appear to do anything. the real reason was so that i didnt have to cut the support on the drivers side fender. if i end up hating them the piece will just run straight across and ill modify the fender.
