Thanks! I never even welded before having this car. There's a lot I need to learn, too. The paragraph below speaks of one such example I should know already...
This weekend I was able to start on the outer half of the inner wheel housing. Again, not able to leave it alone I had to go and modify it for more room. I trimmed it all nice to fit inside flush to the quarter panel only to weld it in and then see it shrink away. Now I have a nice gap (albeit fairly consistent) so I'll need to fill this in. Hopefully I'll get that taken care of next weekend as well as the trunk extension for the driver side.
I also got the Kore 3 hubs- they look so sweet!
|