Quote:
Originally Posted by canrc
Hey Ron -- from what I was told is that the aluminum matrix (Duralcan MMC aluminum) used in the Accu-bond drive shafts is not "weld friendly" but stronger than 6061. The guys at the shop swear by the Mark Williams stuff. Here is a quote from their site:
Accu-Bond driveshafts utilize the Patented (7,485,045), end fitting bonding process that much stronger than conventional welded shafts. The end fitting are produced from 7075 forgings 50% greater strength that conventional welded fittings. The result is a stronger and more accurate running shaft at a reduced cost compared to the Aluminum and Carbon Fiber shafts.
|
Just technical enough to make me try it...
http://www.markwilliams.com/ads/13103-365ND.pdf