The frame is coming together nicely now, I will start to fab the new sheetmetal for the rockers - I have laid out the floor panels and starting layout for the tranny/driveline tunnel.
The frame sits at the bottom of the sill and ties into the body at the A and C pillars.
Test fit of the floor. I am also measuring out the location of the handbrake - on the P1800 its located the the left of the driver between the door and seat.
Another view.
I will also replace the original brake booster and brackets - the original was huge. Some pedal and linkeage mods required.
Now that the frame is in and the body is stable again I will open up the rear sheet metal to tuck my huge rear end away
I'm looking forward to this part.
Also get rid of this seam.
About 1000 spot welds to go...
The tensile strength of these must be pretty high - they seem to eat drill bits.
Cheers!