Fitting the cowl today and nothing was lining up, go figure Taiwan POS, so I measured off the old piece and they are not the same. So I decided to take off the old corner pieces (lines up the fender bolts) and use them instead of the POS already on there.
Just need to POR15 them and then I can weld them in place and start lining up the side cowls.... man it's goood to measure off the frame knowing it's square
I didn't trust those nuts anyway!
Got the cowl level and it lines up now!
Geee ... the bolt holes line up with the firewall now, kool.
Nothing too big ... but that was bugging me so I had to do the right thing
Thanks for looking,
Michael