Sorry for the crappy pictures. I need another lens. Little tough under the car, on my back, with limited light and a 28-135mm lens
. I need one of those fancy lifts
.
Here is a shot of the fill tube on the Fab-9 hitting the crossmember. It is just hitting at full compression but enough that it must be addressed. Probably end up bending another crossmember that goes up a little closer to the floor or change the route it takes. I spoke to Chassisworks about it and they are aware of it but it seems to only be an issue with Fab-9 setups.
Notice the non-existent exhaust clearance. Might have to talk to the guys down the street at Goolsby Customs about raising the trunk floor or something
.
