Here are some pics showing clearance in some other areas at full compression.
There is over 1" of clearance at the frame rail.
This picture is a little misleading but there is a little less than 1" of clearance at the tunnel where the pinion is. The G-Link is basically allowing as much of a drop as possible really unless you want to mod the tunnel.
Here is a shot showing the clearance between the gear case and the body/floor structure above it. When I put in a little pinion angle and I remove the old pinion snubber mount there'll be enough clearance. However, again, IMHO this is as low as you could go without committing to modifying more sheetmetal for clearance. At least with a 9" setup like this. I suppose this case is a little beefier so maybe that is taking up a lot of the space.
