View Single Post
  #267  
Old 06-07-2012, 06:24 AM
Sonar Chief's Avatar
Sonar Chief Sonar Chief is offline
Senior Member
 
Join Date: Dec 2011
Location: Greater Denver area
Posts: 1,366
Thanks: 245
Thanked 163 Times in 72 Posts
Default

Quote:
Originally Posted by makoshark View Post
Where inside the quarter are there rust issues? Around the wheel well lip?
The rust issues can be seen in the photos above, the inside of the quarters up high above the wheelwells, you can also see the rust when you look up straight up from the wheelwells.


Quote:
Originally Posted by Roberts68 View Post
A small sandblaster isn't a bad investment. Do you have enough air to run one is another question? A guy where I used to work had a very small pistol grip style with a hopper on top. Try searching spotblaster, that might be the trade name.

The pot style are cfm consuming beasts and when I borrowed one 2 decades ago is what prompted me to buy my 6.5hp/60gal upright. It has served me pretty well but there are far more impressive compressors out there... albeit they are 4 times the investment and up.

I wanted to ask what primer you are using. I was recommended Dupont dp90 tonight and I don't know anything about primers/paints to speak of.
Yeah I don't have the cfm to run a pot blaster, I have been getting by with a 3hp, someday I would like to upgrade to a 6hp 60 gal 230/1, but that is another big purchase I need to save up for ....

I am using Acme Finish1 epoxy made be Martin Seymour and sold at our NAPA, it is a really nice product and lays down nice. I have used Martin Seymour primers before and they are high quality - hate to pay for just a name such as Dupont.

Thanks for looking ...
__________________
JUST PICTUREShttps://imageshack.com/user/mcavery


Let the house go .... NEVER give up your car!!!!
Reply With Quote