Quote:
Originally Posted by elitecustombody
Not sure where the problem area is, but is sounds like on the actual edge where inner wheelwell is welded with outer quarter panel skin. If that is the area, mask off against overspray, spray some etching primer ,if there should be seam sealer, apply seam sealer,then apply paint followed by clearcoat. I like Sherwin Willams GBP988 etching primer in aerosol can, been using it for 6-8 years ,seems to work much better than U-pol I used before.
|
Thanks for the reply,
Both chips are right at the edge of the lip on the tire side so it's the actual body color. I had to trim the lip for fitment so that edge is bare metal at the moment. I'm pretty nervous about messing with the paint on this car at all so I just wanted to see if what that body shop told me was the right way to go.
because the chips are so small, I had planned to spray some of the self etching primer in a cup and brush it on because I don't want to risk ruining the surrounding paint. The guys at that shop had mentioned priming and putting seam sealer on the exposed edge of the lip that I just ground...does that sound right?