With the upper part of the door in place I moved onto the bottom. Because I added the fender vent in, I also needed to add some metal to the bottom of the door and since I there was rust in bottom corner I just replaced the whole bottom part.
After doing this I decided to to start playing around with one of the quarters so that I could what one whole side of the car would look like.
Off with the old!
I think I've said this before, but I really have no idea what I'm doing. I usually as the guys if I can try something, and they say "sure, go do it."
These seemed like good places to make some cuts...
I tech screwed the fender in place. I need to spend some serious time grinding and hammering before I put it on. Then again maybe I should just buy another and start fresh. My still very basic skills have come a long way since I started, and I probably spend more than half my time fixing everything I do, usually at least twice. The doors and fenders have been cut countless times now. Actually, I've lost count
Rolled out into the light, it still looks as ugly as ever.
