[toddshotrods]

Hmmm, I didn't think it had been this long since I updated this thread.

The upper control arms are getting rod ends, and a little stretch, in place of the upper balljoint.


Some quick surfacing modeling to work out the shape of, and develop patterns for, the front crossmember.


More of the same to develop the electric motor mount. It's going to be "sculpted" out of .250" steel.





Starting on the roll cage. The main hoop will be replaced by retractable twin roll bars, and the cage will be tucked down inside the body. These are the stanchions for the roll bars.