Quote:
|
Originally Posted by 69MyWay
Looking slick!
Here is a challenge for you.
Is it possible to sheetmetal trim the inner upper horizontal lip of the fender so that it is smooth and slick from the exterior lip going into the engine bay? I had thought about doing this on my car because that is an unattractive area that I don't see anybody doing anything about.
|
I don't know if I am following where you are talking about..
Did did cover over the holes where you can see the subframe jam nuts since that was an unsightly area I hated to look at..
__________________
"A ship in port is safe, but that's not what ships are built for."
See Bad Penny run the cones:
https://www.youtube.com/watch?v=8GUPPIX-92U
1971 Chevelle Wagon - Roadster Shop Chassis ProCharged Shafiroff LS and lots of yada yada
1968 Camaro - Project Track Rat - 440 RHS LS