summit order will be in thursday night sometime, after that I can put the rear brakes together. last night I started into something I've been not wanting to do, try and fix this mess!!
this is the mess of wires I have to figure out, some of it I know what its from because I had put the 3 gauges in, but I have to put black wire for the negative wiring, I didn't do that on initial install a few years back. The nest behind the radio I have no idea what's what yet.
all that was on this pic below was some electrical tape, and it wasn't even a good tape job, kinda scary LOL, and of course of the course of a dozen years the tape started to fall off. I'm not that best at this and I could have done it better the first time around!
and there's some wires that I had just thrown some blades on for the gauges a few years back and wedged them on the side of the glass fuses, I have to figure out whats the best wires to splice into for the power to these gauges now that I have a tad more knowledge than I did back then.
should be fun!
Is there a company out there that just makes a blade fuse block to put in place of the glass fuse block? I'd love to get rid of the glass fuses.