Quote:
Originally Posted by LSX67
Use the diagram that you posted, connect blue wire from thermostat to binary switch and then to compressor. Mount the breaker as close to the battery as posable and connect the ground wires to the battery also. I just installed one last week with the battery in the trunk and I had to extend the wires.
|
I have two electric spal fans which are controlled via LS1 PCM. One fan kicks on first and after a while the other fan kicks on, not sure at which temperatures they kick on though. both of them run even if the AC is off.
As for the circuit breaker, you mean I should connect the white wire (ground) to the battery directly. Could you please post a photo that shows where you mounted the breaker in the trunk?