Quote:
Originally Posted by 72Z/28
I have two electric spal fans which are controlled via LS1 PCM. One fan kicks on first and after a while the other fan kicks on, not sure at which temperatures they kick on though. both of them run even if the AC is off.
As for the circuit breaker, you mean I should connect the white wire (ground) to the battery directly. Could you please post a photo that shows where you mounted the breaker in the trunk?
|
Connect circuit breaker (red wire) to battery positive, connect the white wires to battery negative.
You can use bubble sided tape to mount it on the side of your battery if you don't want to drill holes (there's a lot of options). It's not that important where you mount it, as long as it's close to the battery. Also, if you extend the wires make sure to use the same gauge wire then solder an heat shrink the connections. I hope this helps I am not very good at giving directions but I have installed a lot of these units.