Quote:
Originally Posted by 67zo6Camaro
One of the other things that Ron requested was to clean up the existing engine wire harness covering. Which is good, because Im also not a fan of the platic corrugated covering. I have seen it melt and it collects lots of oil and dust from the engine compartment.
Ta DA..... now it's ready for me to route everything nice and tighty. Before I pull the wire tight, I will need to intall the intake, injectors, and all the engine accessories on the front.
|
Nice! The clear-loom covering....I like it. Easy to trace wiring that way ;-)
Funny - just sent you a couple PM's about this very thing. I'm sure you already have something up your sleeve lol.
Also a note sent about the steam tube plumbing - if not done already, it's a good time to plan that one too with the intake/TB out of the way but still with a mock-up or two to go and while you have easy access to the WP.
G.