[coolwelder62]

Today I took a few minute's during Lunch to do a test panel.I tried the smaller of the Tru-Oval's.It's a pc. of 18ga,Cold Roll.The lay out was easy W/ the lay-out top's Dan made up.Then I used a little Joe Gibb's spray lube & 1/4 18V impact Bazingz.!!!!!!!! I am also using a prototype dimple Tool Dan sent me.It make's Small dimple's In size's from 3/16 to 1/2.I did them in Inies outies.Let Dan know what you Think.Thank's DAN,