[ricer]

i know the front tire will be a 25.7" and backs will be 28" (drag radial).

Maybe i am having a brain fart here but without having wheels to put on the car, and the car in the air how will those numbers help me get the front in the general area?

My rear setup isn't an adjustable ride height and without weight on it i can't tell how much compression i will have to see what the actual rocker to ground measurement is. The rear was designed around a 3" drop but is softer so will probably compress more than normal at full weight.

My idea was to try to find someone with a DSE or TVS system with 3" drop and use that measurement to get the spindles is the area of where they will actually be and when fabricating give myself some wiggle room for the downpipe to pass by without interfering.

I know you guys do this stuff all day long so i am just not following you at this point on how to go about it your way, can you explain?