So we have an update from retropower on the body rebuild.
Stu at retropower has started cutting out the wroten panels and is replacing them with GM Approved repair panels provided by AutoMetalsDirect.
As you will see throughout the build, these panels are as good as OEM.
First up, Stu gets the shell mounted on the chassis jig and tackles the front cowl area
As always, the full public album is available here
The Body Rebuild
But here is a preview.
The shell is mounted to the chassis table to maintain its shape once most of its cut out :|
Stu goes wild with the cutting gear. We are building a custom permiter chassis which means custom floor pans and trans tunnnel etc.. so not a lot worth keeping. This will also allows us a 40mm body drop
The complete bulkhead and cowl area is chopped out ready for replacement.
The excellent AMD repair sections are spot welded back in place
Coming together in OEM form. Later in the project, this area will be cleaned up with all the holes removed, and a nice clean firewall fabbed with simple bead lines rolled in for strength. No need for brake servo or wiper motor hole as I have some trick stuff up my sleve for these
The front section all complete
Stu then unpicks the roof skin ready for the next phase of repairs which will start in a couple of weeks
Enjoy, and be sure to check out the full gallery of pics here
The Body Rebuild